By using ultrasonic method you can identify location and orientation of imperfection or the material wall thickness. Ultrasonic method is not strictly limited by thickness, material type and part type. It is possible to detect both internal and surface defects and also both volumetric and planar defects.

This is a comprehensive course for inpiduals with little or no experience in ultrasonic testing; as well as a refresher course for inpiduals who need to brush up on ultrasonic. Through lecture and laboratory exercises; students gain understanding of technical principles and test procedures.

What you will learn

Training is focused on explanation of basic ultrasonic principles and basic knowledge of ultrasonic standards. Practical part is then focused to recognition, positioning and sizing of indications in welds, forgings, castings and pipes. Trainee will also get knowledge about practical limitations and difficulties which can occur during his practice.

Our courses will prepare you to pass the final exam according to SNT-TC-1A or EN 473 code for Level 1, 2 or 3, to be able to operate manually or on automatic lines typical ultrasonic testing.

UT Level I will be able to test parts according to the relevant standards, recognize size and locate the defects in most types of parts, and report them. Level II certified will be trained to inspect according to applicable codes and specifications; and learn to develop procedures instructions for your in-house applications. Classroom training is accompanied by evaluation of study cases; and by practical tasks with testing and evaluation of samples.

Level I training highlights

  • Principles of Ultrasonic Testing
  • UT equipment
  • UT Methods
  • Angle beam and surface wave technique
  • Immersion technique
  • Evaluation of discontinuities
  • Instrument and sensitivity calibration
  • Vertical Linearity Check,
  • Health Safety and Environment

Level II training highlights

  • demonstrate their understanding of the body of knowledge of the NDT method
  • applications Practical applications (evaluation on components)
  • explain the scope and limitations of the method
  • select the proper procedure
  • select the appropriate equipment and accessories for the employer's
  • select the proper calibration standards
  • calibrate the equipment
  • apply the method and
  • interpret and , report and evaluate the results of the NDT

Other information

Every trainee will obtain a set of educational materials, each course contains many specific training tests (with evaluation) and practical knowledge. Alternatively we can provide training suitable for candidates working to a written practice based on EN 473 code.

About Certification

The examination and certification process is directly related to qualification system. In case when the training is performed in accordance with EN473 / ISO 9712 the certificate can be issued by independent European certification body ATG CERT.

ATG offers complex services in NDT = nondestructive testing and qualification training in every standard method of testing: PT, MT, UT, ET, RT, VT, LT. there do qualification special techniques as therell like AWS Radiogragh Interpreter, CR, DR, TOFD, Phased Array or trainings for inspectors and auditors: Auditors/Inspectors, API Q1 Internal auditor, API 510, API 570, 653 or IWI-S/CWI. their products and services are respected worldwide, approved by many national or international bodies.

See all ATG Consulting & Training Services courses

Contact information not available.

Courses you can instantly connect with... Postgraduate Diploma in Engineering Management Lincoln University of Business & Management Training On Industrial Automation (PLC & SCADA) Easy Learn Training Institute Fit out Joinery Manipal Executive Education

Is this the right course for you?

Rate our content

Didn't find what you were looking for ?

or